D.W

[grundlepunch]

I know this is a really stupid question but, why is it bad to have the lower touching the shock mount?

quoted for excellence

[grundlepunch]

lol im fucking lawling myself into a coma over here

anyways, think of what control arms do, and why they move, and why yours cant

[Hydra]

thats why your coils appears bent, because your axle is being held tilted pinion up by the arms, this is most definately what your issue is

[LittleD]

thats why your coils appears bent, because your axle is being held tilted pinion up by the arms, this is most definately what your issue is

Thanks, now i just need to sell all this shit i have laying around so i can afford a Long Arm setup.

[justtorchit]

how bout some less lift... what r u runnign for coils??? damn

[LittleD]

how bout some less lift... what r u runnign for coils??? damn

I think im running 4.5 coils with a 1.75 spacer. I like the look of the high stance which is why i put the spacer in. Im prolly gonna take the spacer out sat/sun and leave it there till i get long arms

[justtorchit]

ummm yeh... your on short arms on stock mounts with 6+ inches of lift.

take that spacer out pronto... bet ya it will drive ten times better

[Hydra]

ummm yeh... your on short arms on stock mounts with 6+ inches of lift.

take that spacer out pronto... bet ya it will drive ten times better

youll prolly need an algnment after you do that

[LittleD]

looked at the front end a bit more today, the lowers do hit so im go nip and tuck some things, the axle side upper control arm bushings are beat cause i can see them rubbing the lip of the bracket.

Also, would a axle joint come into play here? mine is shit and was gonna do that and the unit bearing at the same time

[LittleD]

Fixed the death wobble, my toe was an inch off. Guess when the jack slid off and caught my tie rod, i never adjusted the new one