That thing is going to be sweet. Can't wait to see you continue on it
Announcement
Collapse
No announcement yet.
The Yota Crawler Project
Collapse
X
-
you guys are tell in me, i can't wait either. i wish i had the money for all of it right now. saddly i don't. so baby steps it is
i hope to be painting the frame this weekend, the other body won't come for another couple weeks probably-Ryan
Rigs:07 Toyota Tacoma, 4.0L V6, 6spd Man., 3" Susp. Lift on 33x11.5" Mickey Thompson Baja MTZs, Plenty of Light and Exhaust mods too - SOLD IT!!94 Toyota Pickup/w'93 yota body, 3.0L V6, 5spd Man., Body swapped, Removeable Doors, Rear Locker, 36x13-16 Bias TSLs on 16x7" steel wheels, rock sliders, Custom bed and start of Roll Cage
Comment
-
not sure how far you got with the quick disconnect door setup you quoted at $75...but on mine i unbolted my doors from the hinges, used a die grinder with a cutoff wheel, cut the pins in half and got 5/16" quick release pins from napa... their in the balkamp section, i wanna say 700-XXXX section possibly, their like $6 for 2... way cheaper than $75...
just an idea... and good to see yet another toy build!!87 toy: SAS, detroit, 5 speed swap, 36 TSLs, glass fenders, tons of homemade goodies...scrapped
94 toy: ex cab, 3.slow, bumpers, detroit, 33s, DD
88 Zuki: buick 3.8, th350, linkin it with toy axles, duals, tubified...watch for a build
Lead Foot Fab....keep an out for it...
Comment
-
this is the pin
and the best of the 7 pics of it i have
just dont lose the brass hinge bushings or the door will be wobbly as all hell... and toys are nice, cuz theres no slotting on the hinge bolts, so theres no alignment bullshit to have to screw with....mine got shitty cuz i didnt have inner fenders with my glass fenders, but you might want to scuff em down a little with some 120 grit before you slip em in, and keep WD on em so they dont rust up, much like mine did haha87 toy: SAS, detroit, 5 speed swap, 36 TSLs, glass fenders, tons of homemade goodies...scrapped
94 toy: ex cab, 3.slow, bumpers, detroit, 33s, DD
88 Zuki: buick 3.8, th350, linkin it with toy axles, duals, tubified...watch for a build
Lead Foot Fab....keep an out for it...
Comment
-
that's an idea. i had looked at the hinges to see if i could do anything with them but it didn't look like it would work. i might have to try this now.-Ryan
Rigs:07 Toyota Tacoma, 4.0L V6, 6spd Man., 3" Susp. Lift on 33x11.5" Mickey Thompson Baja MTZs, Plenty of Light and Exhaust mods too - SOLD IT!!94 Toyota Pickup/w'93 yota body, 3.0L V6, 5spd Man., Body swapped, Removeable Doors, Rear Locker, 36x13-16 Bias TSLs on 16x7" steel wheels, rock sliders, Custom bed and start of Roll Cage
Comment
-
Alright. here's another update. I now have the second truck, the one with the bad frame. Picked it up yesterday and went right to work on it. stripped it down so the cab and bed are ready to be swapped over and put back together.
here are a few pics for your enjoyment.
-Ryan
Rigs:07 Toyota Tacoma, 4.0L V6, 6spd Man., 3" Susp. Lift on 33x11.5" Mickey Thompson Baja MTZs, Plenty of Light and Exhaust mods too - SOLD IT!!94 Toyota Pickup/w'93 yota body, 3.0L V6, 5spd Man., Body swapped, Removeable Doors, Rear Locker, 36x13-16 Bias TSLs on 16x7" steel wheels, rock sliders, Custom bed and start of Roll Cage
Comment
-
I have now towed each of those two older yotas and my 07 pulls with out a problem, up hills i just have to stay a gear lower than i normally would. According to Toyota the newer Tacomas with the 4.0L V6 are rated to pull 6500lbs. that's as much as a typical full size pick-up with a small V8. I love that truck.-Ryan
Rigs:07 Toyota Tacoma, 4.0L V6, 6spd Man., 3" Susp. Lift on 33x11.5" Mickey Thompson Baja MTZs, Plenty of Light and Exhaust mods too - SOLD IT!!94 Toyota Pickup/w'93 yota body, 3.0L V6, 5spd Man., Body swapped, Removeable Doors, Rear Locker, 36x13-16 Bias TSLs on 16x7" steel wheels, rock sliders, Custom bed and start of Roll Cage
Comment
-
I love your Tacoma. that is allP8R
2012 Honda Accord - For DD/MPG Porpoises - Cooper Tire: Count on Cooper
2014 Granite Crystal WK2 Limited - Nitto Tire: Fueled by Enthusiasts
Poontang Pro 300EX 42" - For lawn porpoises
OG KOT #4736 Semper Sky Rock Racing/Standardbred Racing Designs 15.5 HP Turbo-Cool Craftsman, 6 Spd w/ crawl box, fat turf treads, Custom paint, and a red onzie
Comment
-
Originally posted by RockClimber View PostI have now towed each of those two older yotas and my 07 pulls with out a problem, up hills i just have to stay a gear lower than i normally would. According to Toyota the newer Tacomas with the 4.0L V6 are rated to pull 6500lbs. that's as much as a typical full size pick-up with a small V8. I love that truck."when I'm riding my motorcycle,I'm glad to be alive...when I stop riding my motorcycle,I'm glad to be alive"
Comment
-
-Ryan
Rigs:07 Toyota Tacoma, 4.0L V6, 6spd Man., 3" Susp. Lift on 33x11.5" Mickey Thompson Baja MTZs, Plenty of Light and Exhaust mods too - SOLD IT!!94 Toyota Pickup/w'93 yota body, 3.0L V6, 5spd Man., Body swapped, Removeable Doors, Rear Locker, 36x13-16 Bias TSLs on 16x7" steel wheels, rock sliders, Custom bed and start of Roll Cage
Comment
Comment