So, how's my gear pattern look?

[iant333]

This is my second pattern after screwing around with the backlash for a little bit. I just want a second opinion before I do the final assembly. Prolly get around to it tomorrow, then it's time for the front.

The Backlash is 0.008
The Pinion preload is between 12-18 in/lbs, i'd say toward the higher end of that though. My torque wrench only goes in half ft/lb increments so that's the best i can say.


Drive:


Coast:



What do you guys think, it time to put the crush sleeve in and finally put it together or is there something I need to change?

[WAD357]

looks good to me comparing it to the chart Ive seen but im FAR from a pro at doing gears

[iant333]

looks good to me comparing it to the chart Ive seen but im FAR from a pro at doing gears

lol same here.

I'm doing this with not really any help and only a few ok sets of instructions I found online so I just want to make sure.

[OWEN]

I would call it good

[LittleD]

Keep me posted on this goes, my gears are getting shipped tomorrow and ill do mine next weeken

[WickedXJ]

Remember to check in at least 3 positions not just the one pictured!