roughcountry longarm

[clean4drxj]

there was a kid over on naxja that was going to sell me his clayton longarm setup but reneg on the whole deal..

[Pedro]

there was a kid over on naxja that was going to sell me his clayton longarm setup but reneg on the whole deal..

Cool story, Hansel

[SupermanIce-J]

great white???? bahahaha

[LittleD]

did u just change my name asshole

[clean4drxj]

great white???? bahahaha

yep

[jeepingxj]

they hang lower than the frame rails...

http://sisoffroad.com/forums/showthr...?t=3228&page=9

ask andrew he has them


if you are looking for cheap you cant beat it.

hope you have an auto because i heard they are hard to install with the ax15



if you want a pretty nice kit, tnt kit can be had for 800ish and has a full belly skid and the arms are tucked up above the frame rails.

I had to cut my Brand new crossmember up and redo it for the Ax15 to bolt up. The Ax15 is shorter than the automatic. Also my bushings wore out in like 3 months which are replacable and they've been warranting.

[clean4drxj]

I had to cut my Brand new crossmember up and redo it for the Ax15 to bolt up. The Ax15 is shorter than the automatic. Also my bushings wore out in like 3 months which are replacable and they've been warranting.

I'm running an AW4 and like I had said before... I dont wheel my jeep all the time and when I do I avoid the mud and water if its possible and it's my one and only vehicle at this point. I appreciate the imput/opinions .

[CumminsJeep]

I had to do the same thing with the AX-15. and RC is sending me new joints next week

[Ktmracer419]

Rough country has stepped up thier game lately. i wouldnt hesitate to run thier kit.

but if i were in the market for longarms and didnt want to build my own, rockkrawler would get my money hands down.

[clean4drxj]

I'm running RE springs, it's just the arms I need because these Crustys are bullshit

[clean4drxj]

went over to clayton yesterday and talk to clayton and adam? and it looks like I'll be holding out a litte longer as i save for their kit, right now I'm half way there!

[HeavyMetal]

in before zullo

[Magilla]

Fuck the clayton kit if you ever have to take it off it is easier to cut the unibody out instead of grinding the welds on the bracket to unibody