made a crossmemba

[Ktmracer419]

FUCK.

See part out thread.

you laugh

but the housing integrity bolt is a serious issue

[Even]

you laugh

but the housing integrity bolt is a serious issue

[HeavyMetal]

serious.

[Magilla]

[Even]

serious.

definetly not serious

[Ktmracer419]

you need to torque it to approximately 84 newton inches. i didnt have a torque wrench handy here so i went by feel. it got him home but after that he could take the vibrations anymore and swapped in a new motor.

all it does is pull in the preload from the t-case to tranny to tranny to engine. just a pain in the balls to get to

[HeavyMetal]

theres a pic right there of it happening.

[Magilla]

you need to torque it to approximately 84 newton inches. i didnt have a torque wrench handy here so i went by feel. it got him home but after that he could take the vibrations anymore and swapped in a new motor.

all it does is pull in the preload from the t-case to tranny to tranny to engine. just a pain in the balls to get to

actually you are wrong it sets the preload on the clutches in the torque converter

[Even]

you need to torque it to approximately 84 newton inches. i didnt have a torque wrench handy here so i went by feel. it got him home but after that he could take the vibrations anymore and swapped in a new motor.

all it does is pull in the preload from the t-case to tranny to tranny to engine. just a pain in the balls to get to

that sounds ultra serious

[Ktmracer419]

actually you are wrong it sets the preload on the clutches in the torque converter

you must use mitchell on demand or shopkey5

they are wrong 98% of the time

[Ktmracer419]

that sounds ultra serious

had to swap that damn motor in the woods using some tree's a tow strap and a winch

[Magilla]

no working in a tranny shop for a long while> neit

[Ktmracer419]

no working in a tranny shop for a long while> neit

musta been a crooked tranny shop, because all that is wrong

[Even]

had to swap that damn motor in the woods using some tree's a tow strap and a winch

i know

[Even]

The noise and vibration was from the t-case rattling on the crossmember.

I adjusted the linkage and something still wasn't right. After fucking around with stuff for a while I found out that I had actually lowered the t-case, instead of raising it I didn't realize I was using a floor jack that leaked, and the t-case dropped down lower than it was supposed to be when I was mocking everything up.

The trans/t-case sits up out of the way now, but the crossmember is going to be getting hung up on shit