Relative axle strengths/ Tech Thread

[OWEN]

I think I just broke a 30 spline dana 60 outer miller locked axle running beadlocked 39s more to come

[Bigbike]

did not know yj 30's went as deep as 5.89 . . . hrmmmmmmm

4.88, YJs are HP

[justtorchit]

I think I just broke a 30 spline dana 60 outer miller locked axle running beadlocked 39s more to come

plz elaborate....

[kev711]

special note for low pinion dana30's. don't put money into them. a high pinion dana30 from an xj is a direct swap and you gain ring and pinion strength as well as a driveshaft that wont spin in the rocks.

any certain year xj?

[Even]

"special note for low pinion dana30's. don't put money into them. a high pinion dana30 from an xj is a direct swap and you gain ring and pinion strength as well as a driveshaft that wont spin in the rocks."

any certain year xj?

You will most likely want anything 96+, which was the year they switched to the 297 ujoints (stronger). Also, very early models had vaccum disconnect.

[Bigbike]

any certain year xj?

84-99 Xjs had HP D30s but your best years to get are 92-99, or 95+ due to bigger ujoints. 84-94 used a smaller ujoint, but you could always put your TJs shafts in to get the bigger ones.

[OWEN]

plz elaborate....

Going up these rock steps


Turns out I just broke the hub, Milemarker Supreme Stainless Sailor Specials the rep said if I ever have a problem to send them back, hopefully they will warranty them I have only wheeled them about 10 times. I'll put a pic up later.

[OWEN]

The weak link. Yes they were locked in all the way.