torque converter chatter?

[Ktmracer419]

just took all bolts out
marked the flywheel

ran the motah and was like "SWEET NO VIBES"

rotated flywheel 180 degrees

put bolts back in fingah tite

then tightened each down

still there

i think i have a bent flywheel though

3 of the holes on the flywheel are flush with the torque converter, and one i have to "pull" in about 1/8". that might not be the cause of the problem, but when im in there ill replace it anyway.

still puzzles me that it was perfect for 60 miles then decided to get all crazy

[ninetysix-ex-jay]

just took all bolts out
marked the flywheel

ran the motah and was like "SWEET NO VIBES"

rotated flywheel 180 degrees

put bolts back in fingah tite

then tightened each down

still there

i think i have a bent flywheel though

3 of the holes on the flywheel are flush with the torque converter, and one i have to "pull" in about 1/8". that might not be the cause of the problem, but when im in there ill replace it anyway.

still puzzles me that it was perfect for 60 miles then decided to get all crazy

Put a strait edge across it. Or pull you old flywheel

[Ktmracer419]

i have 2 good flywheels/flexplates

[crosbike]

flexplate

flywheel is for manual

[Ktmracer419]

flexplate

flywheel is for manual

people know what im talkin about

[CumminsJeep]

flexplate

flywheel is for manual

the whole time reading this thread i was thinking the same thing

[1cleantj]

how is the mount holding t-case/tranny in place ?

[Ktmracer419]

how is the mount holding t-case/tranny in place ?

tranny mount?

[1cleantj]

tranny mount?

yea sure, not familiar with XJ setup so said both figure with an auto if the mount was bad, it would cause some shaking

[Ktmracer419]

yea sure, not familiar with XJ setup so said both figure with an auto if the mount was bad, it would cause some shaking

its 100% coming from the bellhousing. it makes a hella noise

[ninetysix-ex-jay]

flexplate

flywheel is for manual

It fits the definition of a flywheel