Tubing tolerances?

[HeavyMetal]

Yes HREW does have an inner flash unlike DOM, and the typical tolerances are usually about double that of an equivalent piece of DOM. So a piece of 2.5 x 1/4 HREW round tubing has an inner/outer diameter tolerance of +/- 0.012" while a piece of 2.5 x 1/4 DOM round tubing has an inner/outer diameter tolerance of +/- 0.006".

Incidentally Will, I probably have some DOM cutoffs of the right size at work. We do a ton of fabrication work on site and are well stocked with tube, pipe, bar, angle, plate, sheet...... I'll rummage through the scrap bin tomorrow. Do you need 0.250" wall or would 0.188" or 0.125" work as well?

that would be frickin awesome of you...

i really dont need a thick wall tube, .125 would most likely suffice just fine, as long as the thing is a 2" ID. thanks man

[Danksters]

that would be frickin awesome of you...

i really dont need a thick wall tube, .125 would most likely suffice just fine, as long as the thing is a 2" ID. thanks man

How long do you need them?

[HeavyMetal]

How long do you need them?

i think 2 feet would be the maximum i need overall to work with