Tweet
ok, i'm doing a 3" lift on a friends xj, it's a rusty's lift. there's no bracket of any sort or anything to reposition the trac bar please give insight, i could prob figure some stupid way to get the trac bar in but wouldnt the axle be off center??
-
1991 YJ, 1 tons, locked, lots o armor, stretched, cage -
pretty sure ya put it on as is and the axle is just off center...... -
On a rusty's 3" there probably isn't an HD bracket. Just use the TRE trac bar style that hte kit comes with and bolt it to the original mount.
One of the main reasons not to buy rusty's kits...Comment
-
you shouldnt have taken the track bar out when you put the lift in haha. rustys doesnt give any new bracket or new trac bar with their 3 inch kits.
97 TJ that I think is pretty neat.
Comment
-
ya can always just drill/relocate the hole on the axle.....Originally posted by Ktmracer419Comment
-
so what do i do about moving it??1991 YJ, 1 tons, locked, lots o armor, stretched, cageComment
-
-
buy an HD trac bar and mount. NOT RUSTYSI drive a DatsunComment
-
it doesnt need to move. drop the jeep down if it isnt already down on the ground. this will hopefully get it close to the mounting hole. and tell him to get an HD one
97 TJ that I think is pretty neat.
Comment
-
redrilll the hole over like 3/4" so the axles centered again... /threadOriginally posted by Ktmracer419Comment
-
nothin wrong with a rustys 3 inch....
just the rapage of shippingOriginally posted by Ktmracer419Comment
-
Convert it to leafs in the front.
-Caleb
Crawl Daddy Champion 2011
1999 XJ 4 inchs of lift or so, 35s and some other stuff.Comment
-
if you know how to bitch, the shipping usually isn't the problem with themOriginally posted by justtorchit View Post
i wouldn't buy a whole kit from rusty's ever again /threadComment
-
It doesn't need to be relocated, the axle moves about 1" to the drivers side at mostI don't always drink orange juice, but when I do, I prefer to chew it. #madpulpComment
Comment