Announcement

**Magilla** · 03-31-2009, 07:33 PM

it will go through it might take a few minutes. can try a sawzall might work faster.

**~~XJLI~~** · 03-31-2009, 07:35 PM

my $40 ryobi goes right through 1/4

**justtorchit** · 03-31-2009, 07:37 PM

id use a cutting wheel before the sawzall

**Hydra** · 03-31-2009, 07:43 PM

I'd use my portable Milwaukee bandsaw, that thing laughs at 1/4", but a wheel will do the job

**Adam** · 03-31-2009, 07:59 PM

Keep a steady hand and make sure you spin INTO the material and it will cut very smoothly.

**grundlepunch** · 03-31-2009, 08:00 PM

cutting wheel > sawsall

**crosbike** · 03-31-2009, 08:07 PM

yes. itll go through 3/8ths too.

**HeavyMetal** · 03-31-2009, 08:12 PM

itll go through anything as long as its big enough to go to the otherside lol

**Ktmracer419** · 03-31-2009, 09:16 PM

shit will melt

**Rowdy XJ** · 04-01-2009, 04:57 PM

more rpm's da better to cut

**Tom** · 04-01-2009, 06:32 PM

wear gloves and hold the fuck on. keep the wheel straight in the cut and dont let it catch the sides.

can a cutting wheel . . .