pitman arm

[XJLI]

whuat!

Why do i need a straight trackbar?

And i should be able to keep my rusty's bracket, it's pretty much the same as the RE one.

well, any aftermarket one will be too long to run a OTA trackbar, it doesnt have to be straight.

[Even]

you can use my reamer for the pitman arm if I knew who had it.

haha dude i was just going to post in your other thread and be like "ooo ooo can i use it when you find it" thanks dude

And i ordered the 4-6" one from RE, i'm at like 5.5" now so at it's shortest it should be fine, right?

[XJLI]

And i ordered the 4-6" one from RE, i'm at like 5.5" now so at it's shortest it should be fine, right?

no, bc its made to run under the axle.

[Even]

fuck now i gotta hope fullsizexjgear didn't ship my order yet

who sells trackbars set up for OTK

[XJLI]

no one to my knowledge. just get a piece of DOM.

[XJLI]

http://store.jksmfg.com/merchant2/me..._Code=FABParts


but $$

you get the idea.

[Even]

technically couldn't i just cut up the RE one i have ordered and weld it back together

although it probably wouldn't be very cost effective...

[XJLI]

yea, but why would you do that?

[Even]

the jks one would be the easiest but its also mad coin

i see rusty's sells builder parts like flex ends and threaded inserts but i would rather avoid them, who is a good company to order from?

[Ktmracer419]

poly performance

ballistic fabrication

currie enterprises

ruffstuff specialties

rubicon express

[Burton58]

this is my OTK steering. still using the rustys trac bar bracket and stock pitman arm. jks over axle bracket and custom trac bar. you can see how the trac bar and drag link are parallel

[Even]

3 feet of dom is good to go correct?

[Lycaon]

i had the reamer pete, i just gave it to caleb so he can get a head start on his knuckles tomorrow afternoon, im going to his house to install my 1T after i get out of work then one of us will get it back to you, sorry its taking so long

[Fuzzy Wuzzy]

you could cut your RE bar, that's what I did when I ordered the builder kit from TNT. the dude tried to sell me this whole speil with brackets and stuff, but I told him he can either sell me what I want or I'll go somewhere else. He didn't want me cutting up the steel, but fuck him. I had to, since my trackbar was back to stock length.