HHHHWhite Powa Comanche

[crosbike]

So a few updates. Put an older front clip on it and will be swapping stock tires to get it inspected and legal.
Thinking about a bigger axle swap from this

ok not really
Bought another manche, this one runs with a 4.0 & ax15 and is a short bed for $200. Itll get fixed up eventually.
Been cruising the mountains with this bad boy since june, hence the jeep hasnt made much progress

[crosbike]

whelp it passed inspection...now its time to illegalify it again

[crosbike]

Well i had my buddy cory finish weld my rocker panels on and also finished the cage.
The rockers are made out of 1.5"x3" 3/16 wall steel with 4, 1.5" DOM tie ins to the frame and some tube flanges used to increase the weld area.
2 6" welds and a 9" weld connecting the rocker to the cab


frame tie ins,



cage tied into the rocker



also built a headache rack and i will be adding an actual mount for my spare tire.

Cut and folded the rear wheel wells, dont mind the paint i usually just throw some paint on it to keep it from surface rust




Looking to make some tube fenders too, like ericsxj but a bit wider for legality

[Ruepart Hoaxley]

Nice!

[HeavyMetal]

whoa it looks cold there

[crosbike]

whoa it looks cold there

ya, winter comes early at 9000'

[crosbike]

I should update this.

[Lycaon]

I should update this.

[hippie metal]

This.

[crosbike]

Hmm

[CumminsJeep]

Well done. looks great!

I miss you

[Burton58]

Hmm indeed

Sent from my SAMSUNG-SM-G930A using Tapatalk