I NEED a Sye and a cv driveshaft for my Yj

[95jeepYJ]

Like the title says i need a Sye and a Cv because im going spring over axle and its almost summer time so im getting out of school so im going to be doing lots of work on my jeep so if you have a Sye or a place to get a cheap one pm and also if i can pull a Cv driveshaft out of something else from like a junk yard let me know im sure you all know more tricks of the trade than me Thanks

[Magilla]

joker has a np231 tcase with a sye done to it hes trying to sell.

[Ruecifur]

SOA is a VERY INVOLVED project... make sure you research ALOT before taking something like that on.

[95jeepYJ]

Thats why im waiting till summer where i can park the jeep behind the house and do work everyday

[95jeepYJ]

I just need the Sye and Cv shaft first to start it off

[Grandzjtsi]

Look on CL there's a few sets for sale already setup for SOA...with some gerz a lul paint u be stylin mang!

[Ruecifur]

Well FYI, with a SOA you can easily fit 35's, I would put 37-38's on with that much lift... If your gonna rock tires that big, your gonna blow up your axles, so you're going to have to upgrade those too. You'll most likely have to gear those axles, and if you're running that serious of a rig lockers will be in order too. Then think about setting up the brakes, doing a traction bar, upgrading the steering and all sorts of other jazz that I don't feel like typing. If you're not planning on doing axle swaps at the same time, I would just upgrade the stock suspension with a small lift (maybe 2.5") do a 1" body lift, trim the fenders slightly and run 33's. Maybe an aussie or lockrite locker in the rear. You're talking about ALOT of coin to drop into your jeep all at once to do the SOA properly. Stay conservative at first and get out on the trails, you're new to wheeling and learning on a smaller jeep is a good way to start.

[95jeepYJ]

K Well as soon as a put a 2" lift with shackles my U joint Blew Up so i want a Sye and Cv for that reason along with i might be doing another 2 " add a leaf and a 1 " body so id get same lift without going soa the shaft angle will be to great and ill keep blowing Ujoints so i want a sye and cv for atleast that reason if you think that is wise

[Ruecifur]

Yeah for sure... just some unsolicited advice, thats all. Shackle lifts change your pinion angle, which may have had something to do with the u joint failure, but its still a good idea to do the sye. And x2 on hawk's case, you should just grab that cause its done already.

[95jeepYJ]

How can i change my pinion angle i understand now i just ran it threw my head and got it lol i was very confused but the idea is there now

[95jeepYJ]

I would prob have to take axle out cut off axle mounts shift them back an inch then re weld them on huh?

[Ruecifur]

call me tomorrow and i'll help you with some ideas, 203-247-7537 - Mike

[95jeepYJ]

Specific time?

[Ruecifur]

3ish

[95jeepYJ]

K cool