Tweet
Non disco hpD30 4:56's Aussie locker with 297X shafts, raised shock mounts, welded tubes, reinforced pass UCA bracket, and LCA skids, with new UCA bushings, and 3 year old balljoints. comes with a crossover heim steering setup also has a warn diff cover for protection.
NEEDS A NEW RING AND PINION, CROSS PIN AND THE PIN THAT HOLDS IT IN - http://www.4wheelerssupply.com/catal...470_496_23_408
goes for about $200, so we'll say
$500 OBO
Chrysler 27 spline with High clearence shock mounts shaved bottom diff and diff gaurd, 4.56's and welded rear. Comes with ZJ disk brakes and Yukon Alloy shafts and the stock spares. just replaced pinion seal.
this rear is perfect
$400 OBO
both axles are complete other than the front needing the new r&p
also, these are still on my jeep, they will hopefully be out in a week or so pending on me purchasing new axles
NEEDS A NEW RING AND PINION, CROSS PIN AND THE PIN THAT HOLDS IT IN - http://www.4wheelerssupply.com/catal...470_496_23_408
goes for about $200, so we'll say
$500 OBO
Chrysler 27 spline with High clearence shock mounts shaved bottom diff and diff gaurd, 4.56's and welded rear. Comes with ZJ disk brakes and Yukon Alloy shafts and the stock spares. just replaced pinion seal.
this rear is perfect
$400 OBO
both axles are complete other than the front needing the new r&p
also, these are still on my jeep, they will hopefully be out in a week or so pending on me purchasing new axles
Vice President of Internal Affairs at Dirty Donny's House of Hookers
Comment