Crustys Crash Bar and Bracket. Double shear.

[Kyle]

I have my old Rustys Trac bar with Double shear frame end and bracket. The joint on the frame end is just a poly bushing. Nothing amazing. Good for 3" lift. The threaded end stripped out on the bar once already and i sent it to rustys and they welded on a new end. Its been in constant use for the last 2 years in my friends jeep and he finally gave it back after getting a new bar.

$100 shipped.

[bucketokarma]

Pics? I'm looking for something along these lines but I need to see if it's what I'm looking for.

[Kyle]

Ill get pics later.

[Ruepart Hoaxley]

2nd if shane doesn't want it.

[Kyle]

I did not get pics today, hopefully tomorrow.

[Kyle]

PICS


This is the end that Rustys fixed. But i think they chopped off the bad end before welding this new threaded end on so its a bit short so thats why i would say no more then 3" lift. It was on a RE 3.5" lift with doubled up stock coil isolators on the springs and its threaded out this far.

[bucketokarma]

Go for it man .... I have decided to go with Clayton bar & bracket combo.... Thanks

[Kyle]

Bump. $75 shipped.

[Kyle]

BUMP FUCKERS.

[Magilla]

ill take it i need something temporary

[Zullock Holmes]

Go for it man .... I have decided to go with Clayton bar & bracket combo.... Thanks

nice choice

[Kyle]

WILL SOMEBODY PLEASE BUY THIS PIECE OF SHIT ALREADY!

[Kyle]

Bump.

[Zullock Holmes]

if i drive to new hampshire to get this will you give it to me for free, so i can burn it...

And then you won't have to bump this turd.

[Kyle]

if i drive to new hampshire to get this will you give it to me for free, so i can burn it...

And then you won't have to bump this turd.

Tempting but no. if i am going to waste it like that i have other plans for it. I am sure phil could think of a good idea for it.