Dana 60 Feeler

[Zullock Holmes]

Semi-float Solid Axle Dana 60 Rear, Low pinion, 2.75" tube O.D.

Has:
BRAND NEW Superior 5.38 gears, installed, with a Full Spool
35 spline Superior Axle shafts drilled for 5x5.5 or 5x4.5
Disc Brakes with GM Calipers
Clayton Offroad truss with tabs

Currently setup for airshocks/coilovers (no coil buckets)
brackets are set for a double triangulated link setup (high clearance l.c.a mounts)

Everything is BRAND new. Looking to get.... I dunno ~$1300, make an offer.

[Henchman]

Dammit. This is so tempting

[Pedro]

Dammit. This is so tempting

You're gay of you don't

[lilnapsak]

pics? wms?

[Schickos881]

Start of a part out? Dibs on the front 60

[armadasx]

No.no part out.it's just no longer a build on a tight budget.

[Zullock Holmes]

pics? wms?

it's somewhere between 63" and 65". I forget to be completely honest.

Start of a part out? Dibs on the front 60

no part out. Just thinking of upgrading the rear to a Currie 9.

No.no part out.it's just no longer a build on a tight budget.

All nessesary upgrades for increased hp.... kinda.

[customcreationsllc]

How many D60 have you broke that you need to upgrade?

You're never going to finish if you keep changing your build thread.
Next your going to have rockwells

This will be a great swap in for any XJ TJ whatever.
Run 5x4.5 for now and swap the rotors for 5x5.5 when you swap to a D60 front.
or just run 5x4.5 to 5x5.5 adapters and equal out the width at the same time.

I'm running a very similar axle in my buggy, to bad I already have all the components.
I'll ask around.

I'm very tempted for my future TJ project.

[Zullock Holmes]

I got your message, been meaning to call you back. Sorry, been busy.

Basically for me it's a no brainer, the rear end I have now I can sell, and have about half of the cost for building the 9".

I go to a 3rd member with a 5 year warranty and go from semi-float to full-float in the rear, which is something that has been really bugging me. I just don't trust the semi-float shafts with the kind of power i'm gonna be putting down and 39's.

Also it's an easy swap at this point considering the chassis is pretty much roller, just link brackets and shock tabs.

Let me know if you're serious, I have to make some phone calls tomorrow, to get some final prices then I'll know for sure if I'm going to sell. I'd be looking to offload ASAP if I decide to go through with the 9".

[Zullock Holmes]

BUMP!!!

[Zullock Holmes]

BUMP for dat Christmas cash, open to offers! this is a great axle!

[Zullock Holmes]

Price Adjusted to $800, diff just needs to be set up.

[customcreationsllc]

So tempting.
Will those brackets worth with a TJ short arm kit?

[Zullock Holmes]

Nope. They're angled for a double triangulated four link.

You'd need to probably build out but a bracket kit.

The diff isn't set up yet, other than that it's good to go.