Any interest in a C4 Auto trans or a dana 20 transfer case?

[Customjob]

I have a couple c4's one is two wheel drive one is 4 wheel but both can be made into either.

I also have a dana 20 J shift transfer case.

Just figured id post up here first and see if anyone wanted them.

[clean4drxj]

what are you asking for the tcase?

[customcreationsllc]

I have enough projects but the C4 would be cool because they make an adapter to the Ecotec.

http://www.quad4rods.com/docs/quad4r...intcatalog.pdf

[Customjob]

what are you asking for the tcase?

$100

I have enough projects but the C4 would be cool because they make an adapter to the Ecotec.[/url]

I have two one is a case fill the other is a pan fill. The case fill runs the larger flex plate (I think 164 tooth) The pan fill runs the smaller 157 tooth. The case was originally a 4x4 trans but is apart right now because i swaped the transfercase adapter to the pan fill. The pan fill was a 2wd.

[Timmay]

What are you asking for the C4s? I could use a spare.

[customcreationsllc]

$100



I have two one is a case fill the other is a pan fill. The case fill runs the larger flex plate (I think 164 tooth) The pan fill runs the smaller 157 tooth. The case was originally a 4x4 trans but is apart right now because i swaped the transfercase adapter to the pan fill. The pan fill was a 2wd.

I don't know anything about the C4 I just saw that the make a bell housing for Ecotec in case I ever wanted to go automatic but no time soon that would put me way over budget. almost $600 just for the bell.

Standard is cheaper, I bought an ax-15, the bell and clutch for less than $600

If you were throwing them away I would take them just to hold on to them, but if Timmay needs them then give them to him I can always find another C4 if I need one.

Thanks
~Justin

[Customjob]

What are you asking for the C4s? I could use a spare.

Pretty much whatever you feel like giving me. Im looking to offset the cost of my manual a little. They both worked but they leaked a little. The case fill is apart but i think i have all the parts. I also have the torque convertors, flex plates and the motor plates. Let me know, I can bring them to the club comp for ya.

[Customjob]

I have two one is a case fill the other is a pan fill. The case fill runs the larger flex plate (I think 164 tooth) The pan fill runs the smaller 157 tooth. The case was originally a 4x4 trans but is apart right now because i swaped the transfercase adapter to the pan fill. The pan fill was a 2wd.

I just realized i have this backwards
The case fill was the 2wd and had the smaller flexplate.
The pan fill is apart