Tweet
With the warm weather on the way I thought I would bring these to the top of the for sale section to see if anyone has some interest in these again with warmer months on the way. I made 4 pairs of these last year with good results and lots of attention so I hopefully want to expand on it.
For those of you who didnt see these last year, these are the front cherokee doors for a 4-door cherokee, 1 3/4'' .120 wall HREW tube, the front section is 2x2x3/16'' square, the front this year will most likely be round tube since I have the tubing notcher it make it much easier. Unless otherwise specified the latch is still a simple hitch pin latch setup, this year however I'm going to design a setup to use a factory cherokee latch. The pics shown are of the basic door, I could alter it in any way if you want it a little different.
2-door cherokees are of the same design just longer, and lets not forget about wranglers.
Dont look to hard at the last pic, the door isnt actually attached, it wasnt finished yet.
So if anyone is interested just shoot me a pm for pricing, I'll get going on these mid april if not sooner, with the interest people have been taking in my work I've decided to get an LLC to cover my ass so as soon as I'm official work will start. As I gain better tooling look for more stuff soon. Thanks for looking!
For those of you who didnt see these last year, these are the front cherokee doors for a 4-door cherokee, 1 3/4'' .120 wall HREW tube, the front section is 2x2x3/16'' square, the front this year will most likely be round tube since I have the tubing notcher it make it much easier. Unless otherwise specified the latch is still a simple hitch pin latch setup, this year however I'm going to design a setup to use a factory cherokee latch. The pics shown are of the basic door, I could alter it in any way if you want it a little different.
2-door cherokees are of the same design just longer, and lets not forget about wranglers.
Dont look to hard at the last pic, the door isnt actually attached, it wasnt finished yet.
So if anyone is interested just shoot me a pm for pricing, I'll get going on these mid april if not sooner, with the interest people have been taking in my work I've decided to get an LLC to cover my ass so as soon as I'm official work will start. As I gain better tooling look for more stuff soon. Thanks for looking!
pm sent
Comment