Number 10 for dan?

[HeavyMetal]

Ok. How many have you done sir?

that has what to do with what?

[HeavyMetal]

I've seen the old ctjeep club beat the fuck outta their 4.0s upside down reving high rpms without blowing their engine...

yes, plenty of engines see this abuse. hence my point in this thread

[PapaGeno21]

Do they do that for 20 mins at a clip?

The GW runs are not helping matters, the gearing is not helping matters, winding it out driving it like a standard with an automatic is not helping matters.

When you think about it though, he hasnt really blown 10. if 4 of them were hydro locked and bent the rods, thats more so user error. Because i believe the rods coming out the pans was from hydro locking. 2 of those never blew, the flywheel just had wallowed out bolts. 1 of them he litereally didnt like the way it ran, and another pissed oil like a siv. I dunno, this one apparently didnt "blow" but he was on the highway and it just shut down. Will NOT fire back up so he said fuck it.

Im done, its still retarded hes at 10, and if i was him, Id say fuck it as well.

[PapaGeno21]

that has what to do with what?

Because your assuming I dont know what is correct and what is not. Have you swapped engines before? Thats all im asking.

Was more of like a poke at me, so I returned the favor.

Ive pulled my own and dissasembled it, and helped install 2 of them. Watched 3 others. Really not a hard job, just a lot of shit to unbolt and bolt back up.

[XJtheXtremeJeep]

Sounds to me like he just needs to not go in water too deep and he'll be all set.... at this point its just sounds to me like he's using them as trophys or bragging rights

[HeavyMetal]

Because your assuming I dont know what is correct and what is not. Have you swapped engines before? Thats all im asking.

Was more of like a poke at me, so I returned the favor.

Ive pulled my own and dissasembled it, and helped install 2 of them. Watched 3 others. Really not a hard job, just a lot of shit to unbolt and bolt back up.

i have not swapped an engine, (though i was present for one of his, good odds) then again what i said about you was correct, so your point falls on deaf ears. comparing my experience swapping motors to your rock solid guarantee of him not doing 1 thing wrong is flawed based on your engine swapping know how.

me saying hes doing something wrong, is factual. i didnt say he installed it wrong. in fact i referenced water directly. so what was your point again?

[PapaGeno21]

Ouch...

I never noticed you mentioned the water with it.

But yes, that is doing something wrong.

Point taken.

/Thread

[HeavyMetal]

FCK YOU HOMIE G

[PapaGeno21]

EAT SHIT HOMESLICE

[polarman]

A lot of love on the forum today. This heat makes people testy.

[PapaGeno21]

Actually the last post me and him made was an inside joke.

And I wasnt really considering that an argument, more like a discussion of why Dans motors fail on such epic proportions.

[polarman]

What? Inside jokes and sarcasm on SiS forum?
I still thik there is extra anger here today-case and point Joenitros last 2 topics. Issues, man. Serious issues.
But 10 fuggin motors? Something is wrong..I mean, what are the odds?

[PapaGeno21]

Well 9 motors. If he WAS to put in another one, this would be 10. Hes not though. His jeep is not going to move until there is a 350 in it. So its going to be quite some time, as he has more important prioritys right now.

[Burton58]

honestly dan, hydrolocking IS NOT the same as carpooling. you're doing it wrong.

ex. A this is not carpooling

[Saharicon]

JoeNitro! where the fawk are you?!?! This is a man of determination right here. Aint no motor going to hold him down, oh no, you got to keep on movin!