Tweet
Going to be building my Jeep soon so I was trying to figure this out. For a SYE I am going to get the Tom Wood's NP242. I figure it would take about 3-6 weeks to get it ordered and arrive at my house. So would it be accurate enough to measure it stock or would I need to wait till I lift it and put on bigger tires to get an accurate measurement of the angle and all that shit. If I need to wait would it be alright if I just pulled the rear shaft and FWD drove it?
-
99 XJ 4.5" Long Arms & 32x11.5 KM2's -
i'd just use the stock front shaft as your measurement. -
Drive shaft is typically the last thing you order make sure all your angles and such are correct then measure it.
Tom Wood is just a phone call and 5 day shipping.RCrocs #123 Brown CJ-5
www.offroadcustomcreations.com
Sponsors:
Corbeau, Tom Wood, PSC, Polyperformance, Inner Air Lock, Miller Welds, Heavymetal ConceptsComment
-
-
Alright thanks guys99 XJ 4.5" Long Arms & 32x11.5 KM2'sComment
Comment