Unibody side control arm mounts

[Ktmracer419]

yes ma'am

[wannabejeep]

Bump it.

I ordered those brackets, but I'm wondering if My stock arms are gunna work with em.

[Even]

Are you talking about upper or lower CA's?

I looked through real quick but didn't see if you mentioned it.

[wannabejeep]

lower

[Even]

I agree with the others above.

Throw stiffeners on, and weld some new mounts on there. Any welds to the unibody itself will weaken very quickly and rip off.

[crosbike]

ahh the mcpoyles

[wannabejeep]

yep that's the plan. I'm just wondering if those mounts are going to work with my stock arms.

[Even]

yep that's the plan. I'm just wondering if those mounts are going to work with my stock arms.

I would think if they are the same distance away from your axle mounts as the stock ones, they should be fine.

Make sure you do a lot of measuring before hand and post up if anything out of the ordinary pops up.