Announcement

Collapse
No announcement yet.

CV Question.

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    CV Question.

    Im looking for a small CV setup... something thats high angle, and runs a 1/2"-5/8"s shaft...

    Seems too small for automotive, too big for RC stuff... anyone got any ideas?
    "Watching you work on your Jeep is like watching a doctor operate on a cadaver...
    It may be good practice, but in the end it won't do much good." -My Mother.
    Tags: None
  • #2
    Go cart
    2000 xj 4.5 clayton longarms with wontons with a touch of
    97' zj
    2012 surbra imperza DD
    im a motivation machine like the hammer and sickle in communism

    Comment

    • #3
      Thats what im aiming for... where do I source those...
      "Watching you work on your Jeep is like watching a doctor operate on a cadaver...
      It may be good practice, but in the end it won't do much good." -My Mother.

      Comment

      • #4
        Theres bones gocart shop in stratford
        2000 xj 4.5 clayton longarms with wontons with a touch of
        97' zj
        2012 surbra imperza DD
        im a motivation machine like the hammer and sickle in communism

        Comment

        • #5
          http://www.polyperformance.com/shop/...t-p-26767.html

          The 930 cv is commonly used in Porsche's. 28 spline race, might be overkill for what you're looking for, but I looked into using these for a project I was thinking about in the fall.
          No worries, I'm not actually back, I'm just reminiscing about the old days.


          ForSure Motorsports
          Win or Lose, We Booze.


          Vice President of Internal Affairs at Dirty Donny's House of Hookers

          Comment

          Previous template Next
          Working...
          X