96 XJ Floor Pan Replacement

[Bluewarrior7]

So I purchased a floor pan for the driver's side in my 96 XJ Cherokee from a company called Raybuck Autobody Parts. Armand and I were replacing my control arm mounts last night and were about to undertake this project when we realized the floor pan seemed too large to fit? Has anyone had any experience replacing their floor pan? On there site www.raybuck.com it's part #0482-221. If anyone has replaced this part prior does this look compatible, and how difficult a job is this?

[XJLI]

i did mine, bought full pans from sherman auto parts. fit perfect. difficult? well, i could (should) have cut out the old floor and welded in the new floor, but i just cut out the rust, sealed it, then welded the new floors over it.

[Bluewarrior7]

Yeah I saw the entire floor pan last night when I was searching around to see if I had purchased the correct floor pan. But now I have just the drivers floor pan, anybody replace just the drivers side?