Will the lift from a...

[hippie metal]

1987 Chevy 1500 burbon fit my waggy?


Its leafs all around, just as the waggy is. I took quick dimensions and the waggy front leafs are 47.5'' long and 2.5'' wide. The burbons fronts are 47'' long and 2.5'' wide. I still have to take the rear measurements. It was a 6'' when it was new but over time has settled to about a 5". We pulled it apart so he could put the newly built 350 into his trans am But if this would work it'd be a nice free lift. Then all I would need would be gearing and I am built once again

Pics to come when I get time to play with my camera

[Wide-J]

On paper it sounds like it should work fine. Keep us posted on the details.

[JoeNitro]

if the parts are free take them and just try one out if it dont fit ohh well right...

[Hydra]

if the parts are free take them and just try one out if it dont fit ohh well right...

x2, no point in turning them down if they're free

[Ktmracer419]

you can use the leafs from the burb and mate them to your waggy main leaves to likely get some lift.

i would prolly keep the wag main though, that extra half inch of length is worth keeping

[hippie metal]

thanks guys. I will keep you updated on the details

[Henchman]

Just take them. They're free. Can't hurt to try.