Announcement

Collapse
No announcement yet.

Turn signal/hazzard issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Turn signal/hazzard issues

    2000 XJ

    first I didn't get anything when I tried the signals/hazzards....replaced the 5 pin relay in driver compartment and still nothing

    today out of habit I put my signal on and my right one works now, turned on hazzards to check and after a few seconds the left flasher started going off....but not when I try to get it on as a turn signal

    any suggestions?

    doug
    1992 xj Briarwood
    Disconnect d30 5.13 Super 35 kit 5.13 36x14x18 TSL's
    Welded front and rear
    13' LED roof lights
    Disco ball
    Truck nuts
    Spinners

  • #2
    as of the ride home from the bar last night they all work
    1992 xj Briarwood
    Disconnect d30 5.13 Super 35 kit 5.13 36x14x18 TSL's
    Welded front and rear
    13' LED roof lights
    Disco ball
    Truck nuts
    Spinners

    Comment


    • #3
      wiring issue ?

      Comment


      • #4
        my 93 had this problem intermitently, but my brake lights and hazards didnt work at all. i rigged them up to my hitch harness and my brake lights ran a wire right to the switch and it worked. sucked, but worked
        Watch your backhoe, I'm the John Deere man.

        Comment


        • #5
          it was weird, i saw Will at the bar and he said he had the same problem and it cleared itself up, when i started the jeep up maybe 20 mins later it was fixed, he might be a leprechaun
          1992 xj Briarwood
          Disconnect d30 5.13 Super 35 kit 5.13 36x14x18 TSL's
          Welded front and rear
          13' LED roof lights
          Disco ball
          Truck nuts
          Spinners

          Comment


          • #6
            a leperchin



            my jeep also had that issue, cept it went backwards, started completely working, went to left intermittent, to no left, then no right... oh well
            dirty30

            Comment


            • #7
              My signals work fine, but turn on the hazzards and nothing works

              Comment

              Working...
              X