so for a lil project of mine i wana start getting all my steering into double sheer.
ive seen a thread on pirate where a guy took a stock arm and cut the section that goes onto the steering box out. then welded plate onto it to create his double shear pitman arm. I am also in need of a twisted arm like shown in above picture so my heims dont max out.
it will be some time before i go about this because i really dont know too much about welding as far as type of rodz and whatnot. so i see this as a nice little project to learn some good TIG skillz on. and it will also beef my steering up and prep it for hydro assist.
-To weld the cast section to plate steel what type of rod should i use??
Im under the impression pre-heating the metal is a must and am curious to how i should go about doing this...
any input would be great. thnx
Comment