
Announcement
Collapse
No announcement yet.
My black DD build
Collapse
X
-
So I bought Wills old track bar and replaced the RE joint but it blew of course, and the TNT bracket is a POS, So I went up to Clayton, talked to Adam and Matt Z and I got a custom trac bar made up. It is the same one Will has seeing as Claytons strait bars wont fit into JKS brackets because they use 2" currie joints on the axle end, Matt made mine with a bushing on the end, again same as wills. Im putting it in now but the rain has slowed me down.
Leave a comment:
-
Yea i have class at 8 and then i gotta see about a job at 11 in cromwell, so I'm expecting to be home around noonish, so yea give me a shout
Leave a comment:
-
Ill be home tomorrow from like noon till 3, or anytime in the afternoons friday or the weekend.
Leave a comment:
-
If you wanna bring it by my house sometime I can lay some beads for you if you want.
Leave a comment:
-
X2.Originally posted by crosbike View Postya i definitely wouldnt drive it with those welds and 1 stud on the driver side.
Leave a comment:
-
ya i definitely wouldnt drive it with those welds and 1 stud on the driver side.
Leave a comment:
-
Pics because it happened. I havent done the flex shot yet but Im sure you can imagine. I still need to to do litte things like finish getting rid of my LCA brackets, and get some one with a better welder cause mine is sucking donkey nuts right now. but here are the pics


Yes, the side brackets are Emerald Pearl Coat, I ran out of black spray paint, and that was al I had.

These parts need to be installed, Clayton 4.5 inch coils and 10" tavel 5150's
Leave a comment:
-
I just got Clayton Long arms from matt. I installed them tonight, took a short test drive and they where pretty cool. Pics to come tomorow.
Leave a comment:
-
I used the JKS OTA bracket(dont order from JKS directly their shipping is retarted).Originally posted by Hydra View Postwhich OTA bracket did you use? and what did you do for unit bearing/ball joints?
Unit bearing from my 99s original front axle(it is a 99.5 so same unit bearings as a 01 TJ), and
WJ spicer balljoints(the uppers are the same between xj and wj, the lowers are a little diff) I ordered them from alljeep.com, it came to like $100 bucks.
http://www.alljeep.com/oscommerce/pr...ucts_id=167872
OO With the upper ball joints you NEED to compress them a little bit so only the tapered part is showing, just hit the thread part on the ground or something and they will work. Ask me, and my wallet, how I know
Leave a comment:
-
which OTA bracket did you use? and what did you do for unit bearing/ball joints?
Leave a comment:
-
Ok so, the WJ swap is almost done, I have to make the Tie rod I just made a little shorter, and bleed my brakes. Also getting some sweet camber, Im hoping once I get the toe-in correct the camber will go away.
Before Club Comp I need to
Get my WJ swap 100%
Weld on truss
Bump stops
Leave a comment:
Leave a comment: