XJ Dana 30

[customcreationsllc]

I'm looking for an unmolested XJ Dana 30 I don't need the axle shafts just the housing and knuckles

I want it to make a jig so I want one that wasn't wheeled or in an accident.

Thank you,
~Justin

[Bigbike]

I got one Justin, $75 obo.

[TheDude]

I have two.

RM

[iant333]

I got a 2001 low pinion with like no miles on it. 50 Bucks.

[customcreationsllc]

I want to see if I can fabricate my own knuckles like Spidertrax and I was going to use the outer axle for the jig.

I found a YJ d30 in my basement.


Do the YJ's have the same knuckles?

I've seen different unit bearings but I think that just has to do with the ABS?

[clean4drxj]

I guess it would depend on the year

[TheDude]

Justin the C's vary ever so slightly depending on year with the addition of abs and a variety of unit bearing seats for the differences in the respective bearings themselves.Otherwise they are very similar from 1984 to the 2006.
I would say these differences are not enough to warrant an issue as I have installed varying years of unit bearings and other axle components on many d30's without issue.

RM

[customcreationsllc]

Justin the C's vary ever so slightly depending on year with the addition of abs and a variety of unit bearing seats for the differences in the respective bearings themselves.Otherwise they are very similar from 1984 to the 2006.
I would say these differences are not enough to warrant an issue as I have installed varying years of unit bearings and other axle components on many d30's without issue.

RM

Thank you