HP D44 front. $100

[sardo_67]

Bought this for $100, stripped it down then looked into building it since it came out of a bronco. Aaaaaaaaand I can't. It has the useless cast wedge knuckle set up on it so you'll have to figure out some long arm set up or cut them off and sleeve it.

It's good for a center section.

[sardo_67]

Still have

[Schickos881]

Willing to sell just the yoke? 30 spline?

[sardo_67]

No idea what it was, this is a stripped housing. No gears. Just housing and caps

[Schickos881]

Willing to sell just the yoke? 30 spline?

[spanky]

I had that axle I'm my tj.we cut the wedges off worked great

[sardo_67]

I had that axle I'm my tj.we cut the wedges off worked great

then pressed and welded on new tubes?

[spanky]

then pressed and welded on new tubes?

must of been a different axle. it was a 44 from a late 60s bronco i think was a few years ago not really sure .
the one i had the cut off i didnt need to redo the tubes.. sorry must of been a different 44

[DizzDizz]

You can just cut those off, that's what I'm going to do.

[Bigbike]

EB 44s are weld on later ones and later f150s are cast

[sardo_67]

That's on each end...... You guys figure it out of you'd like to run otitis.