Built 1 ton Starter kit

[Toreadorranger]

Artec Full Hydro Truss for Dodge Dana 60 front kingpin axles $300


Rear Axle setup:

03ish Super Dana 70 from a Chevy Van. 4.10 ratio. Has 35 spline shafts and factory dual piston caliper disk brakes. 3.5" Non-taper tubes. Has a 1410 yoke on it. The super 70 has adjusting collars inside like a 14bolt and uses standard dana 70 gears. $400



Trades for Atlas 2, Steering Rockwells, 4l80E trans

[Ruepart Hoaxley]

Is this for the pair? If so, dibs b/c I know someone looking for tons.

[Zullock Holmes]

Good luck with the sale, cool deal

If you do seperate down the road and those Reid Knuckles take a chevy spindle, then shoot me a price and i'd gladly take them off your hands.

[Toreadorranger]

Is this for the pair? If so, dibs b/c I know someone looking for tons.

2000 for the front setup and 500 for the rear setup, but if they want both Id be willing to make a package deal.

[Toreadorranger]

I also have a ruffstuff swap kit for the rear axle for a leaf setup for sale.



http://www.ruffstuffspecialties.com/.../D70SS-35.html

[DizzDizz]

This an awesome deal wish I had the cash. Glws

[Toreadorranger]

rear axle is a 4.10 geared axle.

[Ktmracer419]

wms-wms of the 70?

[Toreadorranger]

~69.5-70"

[Toreadorranger]

I would consider parting out the front end parts if people only want specific parts.

[Toreadorranger]

prices up for parting out the front end.

[Toreadorranger]

Bump,

[Toreadorranger]

new prices.

[Toreadorranger]

bump

[Zullock Holmes]

my price on those knuckles is $380, if you'd be willing to match that i'll take em off your hands instead of buying 'em new, cash moneyzzzz