Tweet
Brand new (non junkyard) LP dana 60 housing (I belive it is a solid axle centersection). 64" wms. with 2 3/4" tubes, welded around. (3/8 wall).
Comes with:
-35 spline open carrier
-set of 35 spline Superior chromolly shafts drilled for 5x5.5 or 5x4.5.
-Clayton Offroad Rear Truss, new style square tube one.
-1310 ubolt style yoke
this axle can be bolt in to an xj, tj, zj, basically stock jeep width (it is not set-up yet) I can arrange for brackets and should a buyer wish i would be willing to set up the bracketry to make this a bolt in axle.
Uses set20 bearing and ford backing plate bolt pattern (can use 8.8 brakes)
Want to see if there is anyone interested in this at this time, I'll let it go for pretty cheap so don't be afraid to make an offer. Any questions, you can either ask here or PM me.
Comes with:
-35 spline open carrier
-set of 35 spline Superior chromolly shafts drilled for 5x5.5 or 5x4.5.
-Clayton Offroad Rear Truss, new style square tube one.
-1310 ubolt style yoke
this axle can be bolt in to an xj, tj, zj, basically stock jeep width (it is not set-up yet) I can arrange for brackets and should a buyer wish i would be willing to set up the bracketry to make this a bolt in axle.
Uses set20 bearing and ford backing plate bolt pattern (can use 8.8 brakes)
Want to see if there is anyone interested in this at this time, I'll let it go for pretty cheap so don't be afraid to make an offer. Any questions, you can either ask here or PM me.
Vice President of Internal Affairs at Dirty Donny's House of Hookers
lol i'll think about it though
Comment