Will you be ready for OER II?

[Ktmracer419]

anyone think their jeep might have to be cobbled together last minute? or not make it at all?

what ya guys need to get done?

got a couple weeks, lets hear it

[Ktmracer419]

personally

other side rear shock mounts fabbed shock installed

new floor on my cargo area

and ima give her a tune up and hope i figure out my hesitation issue while im in there

rear wheel bearings and seals

new rear pads (contaminated from geyah oil)

[SupermanIce-J]

First I need monies...

What I need to get done.

1. Install new rear drive shaft(broke the old one trying to play sam and jumping my jeep)... can only do front digs right now( and leak tranny fluid everywhere.)

2.Replace squeaky idler pulley.

3.Rear bumpstop plates.

4. muffler.( cuz it got ripped off last trip)

What I want to get done (pending money and time).

1.Front prothanes

2.V8 ZJ steering

3. Rear bastard pack or shackle relocation.

[grundlepunch]

cut window in tub to remove snapped body bolts
remove body lift
put drum brakes back together
finish welding shock towers
put on sliders
order new exhaust and fab it up:
EDIT: ordered new cat (slim) and 4" magnaflow muffler. no room with triangulated 4 link!)

if i get to it...
cut off spare tire carrier and cut an old shaft and weld it on (5x5.5 bolt pattern)
change seats


wish me luck

[Clause]

get back to CT...

Replace control arm bushings..
new tires..
traction bar..

[Ktmracer419]

get back to CT...


new tires..

saw that comin lol

[Even]

the only thing i really NEED on the zj is my tires considering i wont be beating the fuck out of it, i could use some new shocks though

but money is getting tight for me right now so that is my main issue

[Customjob]

i need to get mine registered
i want a windshield (removable)
maybe a speedometer and a tach?
and i want to make my transfercase skid fit or get a new one.

[grundlepunch]

personally

other side rear shock mounts fabbed shock installed - omg me 2!

new floor on my cargo area - why is it rusted out???

and ima give her a tune up and hope i figure out my hesitation issue while im in there - that sucks

rear wheel bearings and seals - i did that as well

new rear pads (contaminated from geyah oil) - yup, mine were bad, haha

.

[snowblur17]

so glad this thread was made

-Install:
Shocks
Brakes/Brake Lines
Shackles
Control arms
Tcase
Tcase Skid
Gas tank skid
Header Panel
Front Fenders/Bushwackers

TO DO:
Plate/Box oval'd out rear Spring boxes
Re flare all brake line ends
GET 23 spline t case
Paint springs, skids, other rusted junk
Paint 'ye olde header panel and fenders


Thats just a start..... still don't have sliders and still have stock bumpers. Money has been real tight this summer

[Riot]

This reminds me...
No one bumped the summer plans thread from the previous forum.
Ah, Fuck it, ill make it anyhow.

[justtorchit]

brakelines. proportioning valve. trackbar. steering. diff cover. gearz. yokes. u joints. floor. sliders. exhaust. wheel bearings. paint. shock mounts. battery. test drive. and fix all the problems after that.... FML

[Burton58]

fix leaking sending unit
tie in front and rear bumpers
cut and fold lower rear 1/4's
fine tune front bump stops
replace exhaust
figure out what the noise is coming from my rear disks
modify proportioning valve
new front brake lines

[Bigbike]

Gas tank skid- DONE
Finish rear bumper/ figure out some sort of rear recovery. DONE
Install Detours backbone if it comes in DONE
Install winch pending backbone DONE
Get LTBs mounted on the new rims Not so Done.
Save money Meh.

[Ruecifur]

Gas tank skid/hitch installed(tried today and its giving me problems so I may just not run the hitch)
Finish rear bumper
Install Detours backbone if it comes in
Install winch pending backbone
Get LTBs mounted on the new rims

might i recommend you install one of these too?