ATTN: JoeNitro

[Zullock Holmes]

thank you for the control arms, they are quite nice, but i was looking at the rock rash on them and congratualtions....... you ran them upside down

i just wanted to pubically announce that minor amount of fail

[Riot]

Pm feature.
Mine are upside down too.

[HeavyMetal]

Pm feature.
Mine are upside down too.

i already told you they were right side up. or not backwards. unless you had a double fail going, or unless you changed them since you last asked me

PMs also dont work for public announcements.

carry on.

[Zullock Holmes]

yeaaaa fuck you chris

i wanted to pubically announce this fail. poor joe though he had a bad day, these arms put a nice hole in his head, looked pretty gnarly

[Riot]

The fitting is supposed to be up ?

[HeavyMetal]

The fitting is supposed to be up so a hose would be more difficult to get on it?

the fitting is supposed to be pointing down protruding into anything you drive the jeep over?

go ahead and mount it that way and tell me how that works out for ya

[Zullock Holmes]

yesss and they are protected that way and also by having the tube lower, it allows the axle to drop more before they come in contact with the spring perch there.

[Riot]

Carry on...

[Zullock Holmes]

the fitting is supposed to be pointing down protruding into anything you drive the jeep over?

go ahead and mount it that way and tell me how that works out for ya

hence why the fitting is sheared off one of the ones joe gave me...

[HeavyMetal]

hence why the fitting is sheared off one of the ones joe gave me...

Yessir.

[grundlepunch]

the fitting is supposed to be pointing down protruding into anything you drive the jeep over?

go ahead and mount it that way and tell me how that works out for ya

[Riot]

Rofl nice Dana

[grundlepunch]

why thank you, i was debating using this one:

[HeavyMetal]

im glad u chose the other

[Riot]

Clive pwned