Electrician

[customcreationsllc]

I need an electrician's help
I want to extend my range of my TIG however right now I hard wired it to the wall.
It pulls 94 amps at full power I have a 100amp breaker.
I have about 6ft whip I need to go 25ft would like to use something a little more flexible.
I would like plugs and an extension cored but those plugs have to be expensive so I'm OK with a 25ft whip.

What and where can I find the wire I need and will you help?

Thank you
~Justin

[tjramplebump]

i may possibly be able to help you...shoot me a pm and we'll figure out the material you need

[Zullock Holmes]

I got all my 220 stuff from a supply house, cord and plugs. Couldn't actually find the right stuff at a regular home improvement store.

[hoggie101]

http://www.stayonline.com/reference-...-ampacity.aspx

You could go to valley electric they're usually good

[hoggie101]

http://www.stayonline.com/reference-...-ampacity.aspx

You could go to valley electric they're usually good

[hoggie101]

Id need to know the duty cycle and the kind of welder

[tjramplebump]

iagree. valley is where i buy all my supplys for big jobs i do

[customcreationsllc]

Id need to know the duty cycle and the kind of welder

Miller Syncrowave 250

Link to the Manual
http://www.millerwelds.com/pdf/spec_sheets/AD4-2.pdf


I couldn't find anything at the homecheapo that was flexible.
I ran 3 single 4gage wires 15ft from the fuse panel to the welder.
I wired it in myself.
Thickest wire at homecheapo. Maybe not done right?