Possible Mabell run

[Luke95]

Was talking with Dan today, how does everyone feel about pushing this back a weekend?

I'd be ok with it. But I'd prefer a Saturday, if I break something I can fix it Sunday. I would like to get out and wheel that weekend though. Even if it is local stuff


Luke95

[ct67_72]

I have a few other people who would like to to as well. I don't know if ill be done but I'm gonna try. I'll go either way.

[Buffalo Phil]

Are we doing the 22nd or the 29th?

[ct67_72]

29th

[Buffalo Phil]

Made of win.

[ct67_72]

Just for you buddy!!

[Luke95]

My old transmission is coming out this weekend and Im clocking my tcase. I hope to be done by this sunday.

[ct67_72]

How are you clocking your t-case?
Also Im about 90% sure that my Jeep wont be done. I dont want to rush it back together in typical fashion, just to go wheeling. Im going to wait to get all the parts I want and not shortcut anything.
So full PSC kit will be ordered and most likely the Artec ram mount.

[Luke95]

Im using a jig from Customcreations on here its not going to be alot but I figure it will be worth the 6 pack to use it.

[ct67_72]

Oh to redrill the trans?

[Luke95]

Oh to redrill the trans?

That's the plan


Luke95

[ct67_72]

Do you still have a stock x-member?

[Harry]

If you build a flat crossmember, you can get the case flush with the bottom of the rails without clocking. I did it on mine before I put my doubler in.

[ct67_72]

Right, and with a stock X-member, or any one that hangs down for that matter, clocking the case is pretty much useless.

[Luke95]

If you build a flat crossmember, you can get the case flush with the bottom of the rails without clocking. I did it on mine before I put my doubler in.

Just lifted the tranny?
The shock mount my buddy welded in decided to blow out so in fixing that this weekend tranny got pushed up till next weekend.


Luke95