Open Wheeling Run. June 12, 2011

[ct67_72]

Im out unless someone has a c.v. shaft for a super short sye (34.5" center cap to center cap at ride height) I can borrow
I did everything in anticipation for this and its going to be something this stupid to stop me

[Bigbike]

Im out unless someone has a c.v. shaft for a super short sye (34.5" center cap to center cap at ride height) I can borrow
I did everything in anticipation for this and its going to be something this stupid to stop me

stock xj front shaft wont work?

[Ktmracer419]

the list confuses me.

but if my 60 shaft comes in tomorrow, i drag my jeep out of the woods, and fix my a and b pillars. i may wheel. somehow i doubt it though lol

[Ktmracer419]

stock xj front shaft wont work?

like 4" too short

[HeavyMetal]

hey phil and zullo, can you guys pick something up for me from a guy at "any gas station off of an exit on route 9 or 91 in the central CT area" on Sunday on your way back? if thats cool with you guys, I can tell him yes and get you a time on Sunday

its just a dash piece

[hoggie101]

hey phil and zullo, can you guys pick something up for me from a guy at "any gas station off of an exit on route 9 or 91 in the central CT area" on Sunday on your way back? if thats cool with you guys, I can tell him yes and get you a time on Sunday

its just a dash piece

i can stop and grab it and hand it to phil it he passenger seat if youd like

[HeavyMetal]

That will work

I will keep you guys updated on a time he will be available..ill assume it will be before you guys will be passing through, so it all oughta work out thanks

[Zullock Holmes]

the list confuses me.

but if my 60 shaft comes in tomorrow, i drag my jeep out of the woods, and fix my a and b pillars. i may wheel. somehow i doubt it though lol

people starting asking, i just told everyone they could come.... pretty much in that post....

so much for a crap load of organization. ohhh well.

[Ktmracer419]

shaft didnt come in. ill weld a dana44 spindle and hub to my housing and 3 wheel drive it

shit will be all set for the 19 spline full float locking hub conversion as well.

and duct tape will fix my unibody

[ct67_72]

like 4" too short

yep, tried it lol, half the slip spline was showing

[Ruepart Hoaxley]

I'm out, my right front seized driving it home on break from work...

[Bigbike]

I'm out, my right front seized driving it home on break from work...

Not using mine???

[Zullock Holmes]

i would totally use your jeep if you were there.

[Pdwighty]

Anyone coming from Rhode island area that wants to meet up. If not ill just see everyone at McDonald's.

[Bigbike]

Im in again!