Announcement

Collapse
No announcement yet.

Driveshaft and 1310/1330 conversion u-joint

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Driveshaft and 1310/1330 conversion u-joint

    I found these when i was cleaning up the garage. the driveshaft i had made for a CJ-5 that i had, running 3/4 ton axles and a v-8 driveline (why it is so short). I think this shaft was in for very short, as the motor was way to built for this size u-joint and blew first trip out. I never replaced it, just upgraded, so now its up for sale. I'd like to get $100 for the shaft and ujoint. Slip shaft and splines are more than worth that, esp a nice long travel like this.

    I believe both ends on this are the 1310 joint (not as wide as the 1330)
    extended right before splines are showing:


    Fully compressed:


    U-joint:

    Last edited by Petzl21; 12-19-2012, 08:40 AM.
Working...
X